Subaru Robin RGD3300H - Manual (Page 37)

– 34 –
9-4-3 STATOR AND REAR COVER
(1) Set the stator on the jig.
Match the grooves of the stator with the
grooves of the jig.
(2) Attach the support ring around the stator set-
ting the open ends of the ring to the position
of stator leads.
Check that the hooking holes are placed at
the flat sides of the stator.
(3) Insert four guide bolts into the bolt holes of
the rear cover and mount it on the stator
matching the guide bolts with the grooves of
the stator.
Tighten the guide bolts tentatively.
(4) Take the stator leads out from the window of
the rear cover.
(5) Put a board on the rear cover and press it
using a pressing machine.
If a pressing machine is unavailable, tap
around the board on the rear cover evenly
with a plastic hammer to press fit the rear
cover over the stator.
CAUTION: Take care of the rear cover to
be pressed in upright position.
(6) Join the stator to rear cover with four bolts,
washers and spring washers.
6 ø bolt .......................................4 pcs.
6 ø washer ................................. 4 pcs.
6 ø spring washer.......................4 pcs.
Tightening torque: 7.8 ~ 9.8 N-m (80 ~ 100
kg-cm, 5.8 ~ 7.2 ft-lb)
NOTE: Tighten four bolts evenly taking
several steps.
● The dimensions of the stator bolts are shown in the table below.
Model l s d
RGD3300H
(mm) 85 25 6
(inch) 3.35 0.99 0.24
RGD5000H
(mm) 115 25 6
(inch) 4.53 0.99 0.24
JIG
SUPPORT RING
STATOR
Direction of stator leads
Grooves of jig
Grooves of stator
Hooking holes for removing
support ring
BOARD
6 ø BOLT 4 pcs.
4 pcs.
6 ø SPRING WASHER
6 ø WASHER 4 pcs.
l
s
d
GENERATOR_GS2380.fm 34 ページ ２００７年１０月１日 月曜日 午前９時１３分