Subaru Robin RGD3300H - Manual (Page 41)

– 38 –
(7) Fix the legs of rear cover to the generator base.
Attach the 8 ø terminal of the grounding wires and the clamp to the right side leg of the rear cover at
the same time.
Attach the 8 ø terminal of the grounding wires, a clamp and the BATTERY CABLE (–) and a clamp
to the left side leg of the rear cover at the same time.
NOTE: Two nuts are welded to the bottom side of the GENERATOR BASE.
8 ш Ч 25 mm bolt & washer assy ... 2 pcs.
Tightening torque: 11.8 ~ 13.7 N-m (120 ~ 140 kg-cm, 8.68 ~ 10.1 ft-lb)
(8) Fix the engine mount rubbers to the crankcase bracket.
RGD3300H: 8 ø flange nut......... 2 pcs.
RGD5000H: 10 ø flange nut....... 2 pcs.
Tightening torque: 11.8 ~ 13.7 N-m (120 ~ 140 kg-cm, 8.68 ~ 10.1 ft-lb)
CAUTION: Pay attention to the position of the mount rubbers.
Lift down the engine and alternator assembly and remove the chain block belt.
(9) Attach the stoppers to the frame.
8 ш Ч 12 mm bolt ........... 4pcs. (2 places)
Tightening torque: 11.8 ~ 13.7 N-m (120 ~
140 kg-cm, 8.68 ~ 10.1 ft-lb)
NOTE 1: Set the stoppers so that the
engine base is placed in the cen-
ter of the upper and the lower
rubbers.
NOTE 2: If the engine mount rubbers are
replaced with new ones, set the
stoppers so that the upper rub-
ber touches the engine base. The
new mount rubber shall be dis-
torted by approx. 3mm in one month.
CLAMP
BOLT and WASHER ASSY
CLAMP
EARTH WIRE
BATTERY CABLE (-)
Make this gap even.
Engine base
GENERATOR_GS2380.fm 38 ページ ２００７年１０月１日 月曜日 午前９時１３分