Subaru Robin RGD3300H - Manual (Page 32)

– 29 –
4 Rear Cover In case that “REAR COVER PULLER” is unavailable, remove the
rear cover by the following instructions:
a. Insert the through bolt into the rotor
shaft and tighten lightly.
Do not give a strong
hit on the rear cover
boss or legs. Plastic hammer
b. Hit on the boss at the top of the rear
cover and two legs evenly with a plastic
hammer to remove.
5 Stator (1) Remove the four bolts which join the
stator to rear cover.
10 mm box wrench
(2) Insert a small hook into the hole inside
of the support ring and pull it out.
• If a small hook is unavailable,
remove the stator by the following
procedure:
a. Hold the rear cover and stator
assembly open side down.
b. Place a cushion under the stator to
protect it when dropped.
c. Hit on the bearing housing of rear
cover with a wooden block.
Be careful not to give
a damage to the stator
winding.
Step Part to remove Description Remarks Tool
6 ø BOLT 4 pcs.
4 pcs.
6 ø SPRING WASHER
6 ø WASHER 4 pcs.
SUPPORT RING
GENERATOR_GS2380.fm 29 ページ ２００７年１０月１日 月曜日 午前９時１３分