Subaru Robin RGD3300H - Manual (Page 50)

– 47 –
10-4 NO DC OUTPUT
10-4-1 CHECK THE AC OUTPUT.
Check the generator by following Step 10-1-1 through Step 10-1-3.
10-4-2 CHECK THE DC FUSE.
Check the fuse in the fuse holder.
If the fuse is blown, check for the cause of fuse
blowing, and then replace with a new one.
FUSE: 10 A
NOTE: If the DC output is used to charge a
large capacity battery or an over-dis-
charged battery, an excessive current
may flow causing fuse blow.
10-4-3 CHECK THE WIRING.
Check all the wires to be connected correctly.
10-4-4 CHECK THE DIODE RECTIFIER.
Remove the control panel and check the diode rec-
tifier with a circuit tester.
Refer to Section 8-6 “DIODE RECTIFIER” for the
checking procedure.
10-4-5 CHECK THE DC COIL
Check the resistance between two brown leads from stator with a circuit tester.
If the resistance reading is much larger or smaller than the specified value, the DC coil of the stator is
faulty.
Replace stator with a new one.
MODEL SPECIFICATION RESISTANCE
RGD3300H 60 Hz
120 V
120 V/240 V
0.18
RGD5000H 60 Hz
120 V
120 V/240 V
0.13
FUSE
DIODE RECTIFIER
GENERATOR_GS2380.fm 47 ページ ２００７年１０月１日 月曜日 午前９時１３分