Eaton Electrical 1000 User Manual
Page 16
GETTING STARTED
EATON Power Xpert
®
Gateway Series 1000 Card User’s Guide
S 164201670 Rev 1
12
---------------------------------------------------------
------ Network Settings: Ethernet Port 1 ------
---------------------------------------------------------
1. Dynamic Addressing (DHCP) Disabled
2. IP Address
[None]
3. Subnet Mask
[None]
4. Default Gateway
[None]
MAC Address
00:60:26:10:89:A8
Link Status
Enabled
0. Exit to previous menu
Select an option ==> 1
Enable DHCP? (y/n): n
Figure 12. DHCP Control Option
3.
Type n and press Enter to disable DHCP control.
4.
To set the IP address, type 2 and press Enter. Type the IP address
and press Enter.
5.
To set the subnet mask, type 3 and press Enter. Type the subnet
mask address and press Enter.
6.
To set the gateway, type 4 and press Enter. Type the gateway
address and press Enter.
7.
Type 0 to return to the Network Settings menu (see Figure 13).
---------------------------------------------------------
---------------- Network Settings ----------------
---------------------------------------------------------
1. Ethernet Port 1 Settings
2. Ethernet Port 2 Settings
3. DNS Server (Primary)
: [None]
4. DNS Server (Secondary) : [None]
5. Reset to Factory Defaults and Exit
6. Save & apply all settings
0. Exit without saving
Select an option ==>
Figure 13. Network Settings Menu
8.
If you connected Ethernet Port 2 to a separate network, continue to
Step 9 to assign the IP address for Port 2. Otherwise, continue to
Step 11.