Eaton Electrical 1000 - Manual (Page 8)

GETTING STARTED
EATON Power Xpert ® Gateway Series 1000 Card User’s Guide S 164201670 Rev 1 4
Figure 2. Install the PXGX Series 1000 Card
6. Connect an active Ethernet cable (supplied) to the Port 1 Ethernet
connector on the PXGX Series 1000 Card (see Figure 3).
If you are connecting a second network connection (separate
subnet), connect an active Ethernet cable (not supplied) to the
Port 2 Ethernet connector on the PXGX Series 1000 Card.
Figure 3. Secure the Card and Install the Ethernet Cable
7. If you know the card’s IP address, continue to “Network
Configuration” on page 16; otherwise, continue to the following
section, “Connecting the Card.”