Eaton Electrical 1000 - Manual (Page 77)

OPERATION AND MAINTENANCE
EATON Power Xpert ® Gateway Series 1000 Card User’s Guide S 164201670 Rev 1 73
DIP Switch Description
DIP switch definitions for the PXGX Series 1000 Card are listed in
Table 13.
Table 13. DIP Switch Definitions
S1 Position
Number
OFF Position (Default) ON Position
1 Enable previously stored network
configuration settings (Normal
mode) Override network settings to
assign private IP addresses
(Configuration mode); Port 1 is set
to 192.168.1.1 and Port 2 is set to
192.168.1.2
2 Enable the front panel RJ-45 for
serial communication Enable the front panel RJ-45 port
for communication with an
Environmental Monitoring Probe
(EMP) device for immediate or
future use
3 Normal behavior Reset the HTTP passwords to the
defaults on boot (user and
admin). After a successful boot,
the switch should be turned back
off before rebooting the card.
4 Reserved Reserved
5 Reserved Reserved
6 Normal behavior Reset the card to factory defaults
on boot (after a successful boot,
the switch should be turned back
off before rebooting the card)