Eaton Electrical 1000 User Manual
Page 21
GETTING STARTED
EATON Power Xpert
®
Gateway Series 1000 Card User’s Guide
S 164201670 Rev 1
17
5.
If you will be using host names for controlling access to the card,
enter the Domain, as well as the DNS IP addresses in the
Nameserver fields.
6.
If you will be using Simple Network Management Protocol (SNMP),
identify the physical location of the installed PDU/card (sysLocation
string) in the System location field. This value also appears in the
card’s Web page header bar.
Enter the information to identify someone to contact with questions
about this device (sysContact string) in the System contact field. For
example, you can type a person’s name, phone number,
department, e-mail address, or physical location.
7.
You can also modify the card’s IP address, the subnet mask, and
the gateway address for Port 1 and Port 2 (IP address, Netmask, and
Gateway fields).
8.
Click Apply to save the settings or Discard to cancel the changes.
9.
Continue to Chapter 2, “Configuring the Card” on page 19 for
additional configuration options.
NOTE Once you have logged in as admin, it is important to completely exit the browser to
set the security level back to the standard read-only level.