Eaton Electrical 1000 - Manual (Page 9)

GETTING STARTED
EATON Power Xpert ® Gateway Series 1000 Card User’s Guide S 164201670 Rev 1 5
Connecting the Card
To connect the card to the computer and start the configuration:
1. Plug the RJ-45 end of the supplied configuration cable into the
configuration port on the card labeled “10101” (see Figure 4).
NOTE Verify that you have used the port labeled “10101.” The other ports on the card do
not work for configuration.
Figure 4. Install Configuration Cable
2. Plug the other end of the serial cable into the serial COM port on
the computer.
3. Open your terminal emulation program (such as HyperTerminal).