Eaton Electrical 1000 - Manual (Page 6)

GETTING STARTED
EATON Power Xpert ® Gateway Series 1000 Card User’s Guide S 164201670 Rev 1 2
2. Provide your local network administrator with the card’s MAC
address:
- MAC Address Port 1 _________________________
- MAC Address Port 2 _________________________
The MAC address for Port 1 is located on a label on top of the card.
To determine the MAC address of Port 2, increase the Port 1
address by one. For example: 0060261089A8 (Port 1),
0060261089A9 (Port 2).
3. Contact the local network administrator for the following network
settings:
- IP Address Port 1 (static address*) _________________________
- IP Address Port 2 (static address*) _________________________
- Gateway Address _________________________
- Subnet Mask _________________________
- DNS (name server) IP Address** _________________________
* The PXGX Series 1000 Card provides two network connections
(Port 1 and Port 2), each accessed with separate IP addresses. If
you are setting up the PXGX Series 1000 Card in a dynamic host
configuration protocol (DHCP) environment (default), the network
administrator must set up the DHCP server to provide a static
address each time the card makes a DHCP request. Use Port 2 only
if you need a redundant connection using a separate subnet.
** Obtain the Domain Name Server (DNS) IP address if you plan to
use host names.
4. If you need e-mail functionality, obtain the SMTP IP address or host
name. If using the SMTP host name, verify that you also have the
DNS IP address (see Step 3).
- SMTP (mail server) IP Address or
Host Name _________________________