Eaton POWERWARE 9315 - Manual (Page 96)

COMMUNICATION
EATON Powerware ® 9315 UPS (500–750 kVA) Installation and Operation Manual S 164201691 Rev 1 www.powerware.com 12-10
If you select 1, 2, or 3 from this menu, the following menu is displayed:
Enable/Disable (Function)
Enabled Building Alarm Number(s) 1 4
Enter E# to Enable Building Alarm Number #
Enter D# to Disable Building Alarm Number #
Enter <CR> for No Change
Enter Selection:
Where (Function) indicates the function the building alarm is being programmed for.
The text following the “Enabled Building Alarm Number(s)” label indicates which
building alarms are currently enabled for the function. In this example, Building
Alarms 1 and 4 are enabled. A building alarm can only be programmed for one special
function at a time from these menus. Enabling a building alarm for a special function
automatically enables the alarm. If you disable a special function, the building alarm is
also disabled.
If you select entry 4 from this menu, the following menu is displayed:
Enable/Disable Building Alarm
Enabled Building Alarm Number(s) 1 4
Enter E# to Enable Building Alarm Number #
Enter D# to Disable Building Alarm Number #
Enter <CR> for No Change
Enter Selection:
The text following the “Enabled Building Alarm Number(s)” label indicates which
building alarms are currently enabled. In this example, Building Alarms 1 and 4 are
enabled.
12.5.4 Customize Alarm Messages
If Customize Alarm Message (option 2) is selected from the Program Building Alarms
menu, you can select a custom message for a building alarm or disable a previously
enabled building alarm custom message. When this entry is selected, the following
menu is displayed:
Customize Alarm Messages
Enabled on Building Alarm Number(s) 2 3
Enter Building Alarm Number:
This example indicates that there are custom messages enabled for Building Alarms 2
and 3. When a building alarm number is entered, the message being used by the
software is displayed (either a custom message or the default message indicated by
the list of enabled custom messages). If 1 was entered at the prompt, the following is
displayed:
Building Alarm Active Message: Building Alarm 1 (default
message)
Enter New Message or <CR> for No Change: