Extreme Networks ALTITUDE 4700 - Manual (Page 16)

Hardware Installation
Altitude 4700 Series Access Point Installation Guide 16
the coverage area. Do not mount the access point in a location that has not been
approved in a site survey.
Wall Mounting
Wall mounting requires hanging the access point along its width (or length) using the
pair of slots on the bottom of the unit and the access point mounting template (on the
next page) for the screws.
CAUTION
An access point should be wall mounted to concrete or plaster-wall-board (dry wall) only. Do not
wall mount the access point to combustible surfaces.
The hardware and tools (customer provided) required to install the access point on a
wall consists of:
● Two Phillips pan head self-tapping screws
(ANSI Standard) #6-18 X 0.875in. Type A or AB Self-Tapping screw, or
(ANSI Standard Metric) M3.5 X 0.6 X 20mm Type D Self-Tapping screw
● Two wall anchors
● Wall mount template (included on the next page)
● Security cable (optional third part provided accessory)