Extreme Networks ALTITUDE 4700 - Manual (Page 37)

Altitude 4700 Series Access Point Installation Guide 37
c Optionally enter the IP address of the server used to provide system time to the
access point within the Time Server field. Once the IP address is entered, the
access point’s Network Time Protocol (NTP) functionality is engaged automatically.
d Define a primary and alternate WIPS server IP Address for WIPS Server 1 and 2.
These are the addresses of the primary and secondary WIPS console server. WIPS
support requires an Extreme Networks AirDefense WIPS Server on the network.
WIPS functionality is not provided by the access point alone. The access point
works in conjunction with the dedicated WIPS server(s).
NOTE
Refer to the Altitude 4700 Series Access Point Installation Guide to optionally set a system
location and admin email address for the access point or to change other default settings.
4 Refer to the new Radio Configuration field to define how WLAN and WIPS are
supported by the access point’s radio(s). Remember, the options available depend on
the dual or three radio model SKU deployed.
NOTE
If using a three radio model Altitude 4750 Access Point, the radio three configuration option
could be rendered unavailable if Rogue AP detection is enabled, or if the power source cannot
provide adequate power for the third radio.
The Quick Setup screen on the previous page displays the Radio Configuration field
with all 8 radio button options available. This is only the case with three radio access
point SKUs. A dual radio model access point would display 7 of the eight possible
configuration options. Refer to the following table for the options available to dual and
three radio models.