Extreme Networks ALTITUDE 4700 - Manual (Page 21)

Altitude 4700 Series Access Point Installation Guide 21
power switch. The Power Injector receives power as soon as AC power is
applied.
For standard 48 volt power adapter (5014000247R) and line cord installations:
a Connect RJ-45 CAT5e (or CAT6) Ethernet cable between the network data supply
(host) and the access point’s GE1/POE port.
b Verify the power adapter is correctly rated according the country of operation.
c Connect the power supply line cord to the power adapter.
d Attach the power adapter cable into the power connector on the access point.
e Plug the power adapter into an outlet.
For PoE-enabled switch or controller installations:
a Connect an RJ-45 CAT5e (or CAT6) Ethernet cable between a PoE-enabled port
and the access point’s GE1/POE port.
b Ensure the cable length from the PoE-enabled port to the access point does not
exceed 100 meters (333 ft).
c Verify power is enabled on the PoE-enabled port.
CAUTION
Do not actually apply power to the AP until the cabling portion of the installation is complete.
6 Verify the behavior of the access point LEDs. For more information, see “LED
Indicators” on page 26 .
7 Align the bottom of the ceiling T-bar with the back of the access point.
8 Orient the access point chassis by its length and the length of the ceiling T-bar.
9 Rotate the access point chassis 45 degrees clockwise.
10 Push the back of the access point chassis on to the bottom of the ceiling T-bar.