Extreme Networks ALTITUDE 4700 - Manual (Page 25)

Altitude 4700 Series Access Point Installation Guide 25
12 Extreme Networks recommends attaching safety wire to the access point safety wire
tie point or security cable (if used) to the access point’s lock port.
13 Align the ceiling tile into its former ceiling space.
14 Cable the access point using either the Power Injector solution or the power supply.
For Power Injector installations:
a Connect a RJ-45 CAT5e (or CAT6) Ethernet cable between the network data
supply (host) and the Power Injector Data In connector.
b Connect a RJ-45 CAT5e (or CAT6) Ethernet cable between the Power Injector
Data & Power Out connector and the access point’s GE1/POE port.
c Ensure the cable length from the Ethernet source to the Power Injector and access
point does not exceed 100 meters (333 ft). The Power Injector has no On/Off
power switch. The Power Injector receives power as soon as AC power is
applied.
For standard 48 volt power adapter (5014000247R) and line cord installations:
a Connect RJ-45 CAT5e (or CAT6) Ethernet cable between the network data supply
(host) and the access point’s GE1/POE port.
b Verify the power adapter is correctly rated according the country of operation.
c Connect the power supply line cord to the power adapter.
d Attach the power adapter cable into the power connector on the access point.
e Plug the power adapter into an outlet.
For PoE-enabled controller installations:
a Connect an RJ-45 CAT5e (or CAT6) Ethernet cable between a PoE-enabled
controller port and the access point’s GE1/POE port.
b Ensure the cable length from the controller port to the access point does not
exceed 100 meters (333 ft).
c Verify power is enabled on the controller port.
CAUTION
Do not actually connect to the power source until the cabling portion of the installation is
complete.
15 Verify the behavior of the access point LED light pipe. For more information, see
“LED Indicators” on page 26 .
16 Place the ceiling tile back in its frame and verify it is secure.