Extreme Networks ALTITUDE 4700 - Manual (Page 32)

Basic 4700 Series Configuration
Altitude 4700 Series Access Point Installation Guide 32
If initially connecting to the access point through the LAN port:
a The LAN (or GE1/POE) port default is set to DHCP. Ensure the access point’s
GE1/POE port
can obtain its IP address from a DHCP server. The access
point should receive its IP address automatically.
b To view the IP address, connect one end of a null modem serial cable to
the access point and the other end to the serial port of a computer
running HyperTerminal or similar emulation program.
c Configure the following settings:
■ Baud Rate - 19200
■ Data Bits - 8
■ Stop Bits - 1
■ No Parity
■ No Flow Control
d Press <ESC> or <Enter> to access the access point CLI.
e Log into the CLI using admin as the default User ID and admin123 as the default
password. As this is the first time you are logging into the access point, you are
prompted to enter a new password and set the county code.
f At the CLI prompt (admin>), type “summary”. The access point’s LAN IP address
will display.
g Using a Web browser, use the access point’s IP address to access the
access point.