Extreme Networks ALTITUDE 4700 - Manual (Page 39)

Altitude 4700 Series Access Point Installation Guide 39
NOTE
The AP4700 GE2 port will not be enabled unless a POE power source is used that supplies
802.3at power to the access point's GE1/POE port. Make sure an APPSBIAS1P3AFR model
Power Injector is used to ensure 30 WATTS of power is available to enable the WAN port. If a
legacy 802.3af power supply is utilized, the GE2 port will not be operational.
a Select the Enable WAN Interface checkbox to enable the WAN port. Disable this
option to effectively isolate the access point’s WAN connection. No connections
to a larger network or the Internet will be possible. MUs cannot communicate
beyond the configured subnets.
b Select the This Interface is a DHCP Client checkbox to enable DHCP for the access
point WAN connection. This is useful, if the connected network uses DHCP.