Extreme Networks ALTITUDE 4700 - Manual (Page 18)

Hardware Installation
Altitude 4700 Series Access Point Installation Guide 18
To mount the access point on a wall using the provided template:
1 Photocopy the template (on the previous page) to a blank piece of paper. Do not
reduce or enlarge the scale of the template.
CAUTION
If printing the mounting template (on the previous page) from an electronic PDF, dimensionally
confirm the template by measuring each value for accuracy.
2 Tape the template to the wall mounting surface.
● If the installation requires the antenna be positioned vertically, the centerline
reference (of the template) needs to be positioned vertically. The cabling shall exit
the access point in a vertical direction.
● If the installation requires the antenna be positioned horizontally, the vertical
centerline (of the template) needs to be positioned horizontally. The cabling shall
exit the access point in a horizontal direction.
3 At mounting targets A and B, mark the mounting surface through the template at
the target center.
4 Discard the mounting template.
5 At each point, drill a hole in the wall, insert an anchor, screw into the anchor the
wall mounting screw and stop when there is 1mm between the screw head and the
wall.
If pre-drilling a hole, the recommended hole size is 2.8mm (0.11in.) if the screws are
going directly into the wall and 6mm (0.23in.) if wall anchors are being used.
6 If required, install and attach a security cable to the access point lock port.
7 Attach the antennas to their correct connectors.
8 For information on available antennas, see “Antenna Options” on page 14 .
9 Place the large center opening of each of the mount slots over the screw heads.
10 Slide the access point down along the mounting surface to hang the mount slots on
the screw heads.
CAUTION
Ensure you are placing the antennas on the correct connectors to ensure the successful operation
of the access point.