Extreme Networks ALTITUDE 4700 - Manual (Page 31)

Altitude 4700 Series Access Point Installation Guide 31
3 Basic 4700 Series Configuration
To access the access point via the GE1/POE port, the GE1/POE port default setting is
DHCP client. To access the access point via the GE2/WAN port, the default WAN IP
address is 10.1.1.1. For optimal viewing of the Web UI, the screen resolution should be
set to 1024 x 768 pixels or greater.
NOTE
For advanced configuration options beyond the scope of this guide, refer to the Altitude 4700
Series Access Point Product Reference Guide. The guide is available on the Extreme Networks
Web site, at
http://www.extremenetworks.com/go/documentation .
NOTE
For optimum compatibility, use Oracle’s JRE 1.5 or higher, and be sure to disable Microsoft’s Java
Virtual Machine if installed.
NOTE
The computer being used should be configured to use the same IP address and subnet mask as
the access point.
1 Connect to the access point using either the access point's WAN (GE2) or LAN
(GE1/POE) port.
If initially connecting using the access point's WAN port:
NOTE
The AP4700 GE2 port will not be enabled unless a POE power source is used that supplies
802.3at power to the access point's GE1/POE port. Make sure an APPSBIAS1P3AFR model
Power Injector is used to ensure 30 WATTS of power is available to enable the WAN port. If a
legacy 802.3af power supply is utilized, the GE2 port will not be operational.
a Ensure the access point has power.
b Start a browser and enter the access point’s static IP address (10.1.1.1).