Epson Multi-mode Data Controller MFJ-1278B - Manual (Page 124)

MFJ-1278B MULTI-MODE ADVANCED OPERATION
stored in the system EPROM. The bbRAM memory stores most of the parameter values in a
permanent, but easily changed form.
The following commands set special characters that are active in Command Mode. Please
refer to the discussions of the special character commands in Chapter 6 for details on the
operation of the characters in Command Mode. Also see the section on special input
characters in Chapter 4.
CANLINE
Cancel current line
CANPAC Cancel output (Command Mode function only)
DELETE Character deletion
PASS Insert following special character
REDISPLA Re-display current line
START, STOP User's flow control characters (sent to MFJ-1278B)
XOFF, XON MFJ-1278B flow control characters (sent to terminal)
The following commands enable display features that are active in Command Mode. Please
refer to the discussions of these commands in Chapter 6 for details on the operation of these
characters in Command Mode. Also see the section on terminal configuration in Chapter 4.
AUTOLF
Add <LF> after <CR> in data sent to terminal
BKONDEL Echo after character deletion
ECHO Automatic echo of serial port input
FLOW Type-in flow control
LCOK Lower case translation
NUCR Nulls after <CR>
NULF Nulls after <LF>
NULLS Null count
SCREENLN Automatic <CR> insertion
Entering Data-Transfer Modes
There are several ways to enter a data-transfer mode from Command Mode. You can type
the command CONVERS or K to enter Converse Mode or the command TRANS or T to
enter Transparent Mode, and the MFJ-1278B will immediately enter the specified mode. If
the user is in Command Mode and establishes a Packet connect, then the MFJ-1278B will
enter a data transfer mode. You can specify the data-transfer mode for automatic entry with
the command CONMODE:
cmd: CONMODE TRANS
will specify Transparent Mode to the MFJ-1278B when the user establishes a connect, and