Epson Multi-mode Data Controller MFJ-1278B - Manual (Page 174)

MFJ-1278B MULTI-MODE OPERATIONAL COMMANDS
means that the command CONNECT requires a callsign argument, call1. You may
optionally include the keyword VIA, followed by a list of one to eight callsigns, call2
through call9. The callsigns in the list, if included, must be separated by commas (as
shown), or by blank spaces. An acceptable command might be C N2WX V AD7I
WB9FLW.
You can see the current value of the command's arguments by typing the command name by
itself, without any arguments. For example,
cmd: CONOK Y
Sets the value to YES (ON).
CONOK was OFF Displays previous value.
cmd: CONOK Command with no arguments
CONOK ON Displays present value.
A special command, DISPLAY, allows you to see the values of all parameters or groups of
related parameters.
Remarks
This section describes the command's action and the meaning of each argument. Examples
may be included of situations in which the command might be used.
All of the commands available in the MFJ-1278B are listed in the following pages. The
commands for all of the other modes besides PACTOR are shown in bold UPPER case
letters, such as TXDELAY. The commands listed for the PACTOR mode are shown in bold
UPPER and LOWER case letters, such as CWIdmode. The PACTOR commands are
executed from the PACTOR p_cmd: command prompt.