Epson Multi-mode Data Controller MFJ-1278B - Manual (Page 361)

MFJ-1278B MULTI-MODE APPENDIX H COMMAND SUMMARY
Command Paramete
r Default Mode Function Page
BKONDEL ON|OFF on Packet Determines the way the screen is updated
when a character is deleted in the
command mode. 6-19
BLP ON|OFF on Packet Allows Host Mode operation 6-20
BTEXT text blank Packet Specifies the text of the beacon packet. 6-21
BUDLIST ON|OFF off Packet Determines if the packets listed in
LCALLS are to be displayed. 6-22
BUF n 0-9 CW/RTTY/ Allows addressing of the ten user ASCII
programmable memories. 6-22
BUFKEY nnn 9 CW/RTTY/ Allows the user to transmit the ASCII
buffer without using the (CTRL-T). 6-23
BUFTIME n 0 CW Used to transmit buffer 0 when it is a non-
zero value at the set interval. 6-23
BWNL ON|OFF off AMTOR Causes the MFJ-1278B to transmit when
it receives a <CR>. 6-23
CALIBRA -- I-command All Used to transfer the control to the modem
calibration routine. 6-24
CALSET n 0 All Specifies the count setting for use by the
calibration routing. 6-24
CANLINE n $18 (^x) Packet Changes the cancel-line input editing
command character. 6-25
CANPAC n $19 (^Y) Packet Changes the cancel-packet input editing
command character. 6-26
CBELL ON|OFF off Packet Sends a bell tone through the computer or
terminal speaker when a packet
connection is made. 6-27
CBell ON/OFF OFF Pactor Sends a bell through the computer
terminal speaker when a Pactor connect is
established. 6-27
CCITT ON|OFF on RTTY Determines whether U.S. standard or the
internationally recognized character set is
used. 6-28
CHANGE - I-command AMTOR Switches from receiver to transmitter in
AMTOR mode A "ARQ". 6-28
CHAT - I-command M-Packet Allows SYSOP to break onto the
mailbox's connected link. 6-28
CHECK n 30 Packet Sets a connection timeout. 6-29
CHECKV1 ON|OFF off Packet Enables the automatic idle-link-
disconnect feature for AX.25 L2V1
connections. 6-29
CHObell ON/OFF on Pactor Sends a bell tone to the computer or
terminal when a Pactor changeover is
done. 6-30
CHOChar nnn 25 Pactor Designates the Pactor changeover
character. 6-30
CMDchr nnn $03 Pactor Deisgnates the Pactor return to command
mode character. 6-30