Epson Multi-mode Data Controller MFJ-1278B - Manual (Page 27)

MFJ-1278B MULTI-MODE RADIO INTERFACING
RADIO PORTS CONNECTION
The MFJ-1278B gives the user two (2) radio ports. This allows for both FM and HF
operation from either radio port. Since the radio ports are independent of each other, the user
is not restricted to FM or HF operations. The radio ports on the MFJ-1278B allow an FM
radio and an HF radio to be connected at all times. In fact you can have any combination of
HF radios or VHF radios connected to the radio ports at any time. The pin designations for
both radio ports are exactly the same. See Fig. 3-1 for the radio port pin designations. The
radio ports on the MFJ-1278B are switched by using the RADio command. We will discuss
radio port switching in the next chapter.
Once the user obtains the proper microphone connector (not provided), use Fig. 3-2 to wire
the 5 pin DIN cable (provided) to the microphone connector. If two radios are to be used
with the MFJ-1278B, you will need to wire two radio cables.
You may obtain the specific pin designations for your radio's microphone connector from
your radio's manual. Appendix A at the end of this Instruction Manual lists pin assignments
for some of the most popular radios. The accuracy of this information is not guaranteed.
You should verify this information with your radio manual.
Fig. 3-2 Radio Connector Pin Diagram
Two 5-pin male DIN cables are provided with the MFJ-1278B. These cables have a 5-pin
DIN connector on one end, with the other end of each cable being unterminated. The
unterminated end of each cable is for wiring the appropriate microphone connector which
matches your radio.
CHECK THIS CABLE WITH AN OHM METER TO IDENTIFY EACH
WIRE BEFORE WIRING IT TO THE MIC CONNECTOR THAT FITS
YOUR RADIO.