Epson Multi-mode Data Controller MFJ-1278B - Manual (Page 278)

MFJ-1278B MULTI-MODE OPERATIONAL COMMANDS
STREAMCA ON/OFF Mode: Packet Default: OFF
Parameters:
ON
Callsign of other station displayed.
OFF
Callsign of other station not displayed.
This command is used to enable the display of the connected-to station after the stream
identifier. This is particularly useful when operating with multiple connections allowed. It is
somewhat analogous to the use of MRPT to show digipeat paths when monitoring.
In the example below, the charaters inserted by enabling STREAMCAll are shown in bold
face type.
A:K4NTA:hi howie
ello ted how goes it?
B:WA7GXD:*** CONNECTED to WA7GXD
Bmust be a dx record. ge lyle
Aunreal ted! fl-az no digis!
B:WA7GXD:big band opening...ge
etc.
The same sequence with STREAMCAll OFF would look like the following:
Ahi howie
hello ted how goes it?
B*** CONNECTED to WA7GXD
Bmust be a dx record. ge lyle
Aunreal ted! fl-az no digis!
Bbig band opening...ge
etc.
Thus, what would have looked like "|B" now appears as "|B:<callsign>:". This option is very
useful for human operators trying to operate multiple simultaneous connections. It is
probably less useful for "host" operations.
Note that, in the first example, the STREAMSWitch characters "|A" and "|B" with no ":"
after them were entered by the operator of the TNC to switch streams for his multiple-
connect QSO(s). If you intend to operate multiple connections (as opposed to having your