Epson Multi-mode Data Controller MFJ-1278B - Manual (Page 299)

MFJ-1278B MULTI-MODE SYSTEM MESSAGES
?not enough
You did not give enough arguments for a command that expects several parameters. For
example the command to initiate a beacon every 10 seconds is B E 1. If you issue the
command B E the MFJ-1278B gives this message. The MFJ-1278B knows there is supposed
to be another argument.
?not while connected
You attempted to change MYCALL or AX25L2V2 while in a connected or connecting state.
In order to eliminate this message either disconnect or halt the connect attempt, then change
MYCALL or AX25L2V2.
?range
A numeric argument for a command was too large.
?too long
You entered too long a command line, and the line was ignored. This might happen, for
example, if you try to enter too long a message with BTEXT or CTEXT. If you get this
message, the previous text entry was not changed.
?too many
You gave too many arguments for a command that expects several parameters. For example,
MFILTER if you issue the below MFILTER command to the MFJ-1278B:
cmd: MFILTER $1B,$0C,$1A,$03,$07
?too many
The MFJ-1278B gives the ?TOO MANY message because the maximum arguments for the
MFILTER command is 4.
?VIA
This message appears if you attempt to enter more than one callsign for the CONNECT or
UNPROTO commands without being proceeded by the VIA keyword. For example:
C AA5XO AA5MT (No VIA between callsigns)
should be
C AA5XO VIA AA5MT Notice the VIA between callsigns.