Epson Multi-mode Data Controller MFJ-1278B - Manual (Page 212)

MFJ-1278B MULTI-MODE OPERATIONAL COMMANDS
DAYUSA ON/OFF Mode: Packet Default: ON
Parameters:
ON
Date is displayed in the format mm/dd/yy.
OFF
Date is displayed in the format dd-mm-yy.
This command determines the format for the MFJ-1278B's display of the date. If DAYUSA
is ON, the standard U.S. format is used; if DAYUSA is OFF, the standard European format
is used. This command affects the format of the date display used in "time stamps" as well as
the display when DAYTIME is entered without parameters. The format for entering the time
using DAYTIME is not affected.
For example, if DAYUSA is ON, then July 2, 1984 at 9:28:44 AM would be displayed as
cmd: DAYTIME
07/02/84 9:28:44
If DAYUSA is OFF the same date and time would appear as
cmd: DAYTIME
02-07-84 9:28:44
DDisc
Mode: Pactor Immediate Command
The DDISC command is used as a last resort for terminating a PACTOR link. This will work
where at times the standard DISCONNECT will not. The use of this type of termination is
considered RUDE so this is why it is a last resort.
Disconnect
Mode: Pactor Immediate Command
This command is exactly like the DISCONNECT command in Packet. When this command is
issued from the p_cmd: prompt a disconnect sequence is initiated. The DISCONNECT
command is what operators normally used to terminate a Pactor link.
DISplay
Mode: Pactor Immediate Command
The DISPLAY command will display all PACTOR commands and their settings. This is the