Epson Multi-mode Data Controller MFJ-1278B - Manual (Page 297)

MFJ-1278B MULTI-MODE SYSTEM MESSAGES
too many packets outstanding
This message would appear in response to a CONVERS or TRANS command, under special
circumstances. If you have previously entered packet data, filling the outgoing buffer in
Converse Mode or Transparent Mode and then returned to Command Mode. You will be
allowed to enter one of these modes when some of the packets have been successfully
transmitted.
Mailbox Messages
? Expected bank n....x
This message occurs when you try to switch to an extended Mailbox memory bank which
does not exist. For example trying switch to memory bank 8, using the 512K memory
extension. Memory bank 8 does not exist, only banks 0 thru 7 are present.
You have new mail!
Upon accessing the mailbox, this message will appear if there are any new messages
addressed to you. These will be the messages with the N message flag set. Once the message
is read and the Y message is set, this message will not occur.
Message saved
The Message Saved occurs when a Mailbox message is actually stored after pressing the
CTRL-Z and ENTER. This message also appears if the /EX and ENTER.
Cannot, not yours
This message occurs when a remote user attempts to kill a message that is not his, or he tries
to read personal message by or for someone else. The SYSOP can READ or KILL any
message in the Mailbox system.
?Mailbox full
This message occurs when either all of the available slots are full, or the actual message
space is full. The number of slots and message space for the different mailbox versions are as
follows:
Memory size # Slots Message Space
Unexpanded* 30 2,900 Bytes
32K** 99 32,000 Bytes
128K** 99/Bank 128,000 Bytes
512K** 99/Bank 512,000 Bytes