Hayes Microcomputer Products DIVA T/A ISDN - Manual (Page 100)

DIVA T/A ISDN Modem User’s Guide 100
Calling Features
(North America only)
Note: If you did not use EZ-ISDN or IOC to order your line, verify
that the DIVA T/A’s default settings are compatible with those of your
ISDN provider before using this feature. Refer to the section “Feature
Key Values” on page 102 for more information.
Note: To use Calling Features, your ISDN line must support the
following: Additional Call Offering (ACO) and Flexible Calling (FC).
If you ordered your ISDN line using the proper EZ-ISDN code, you
should have access to these features. See also, “Using EZ-ISDN or
ISDN Ordering Code (IOC)” on page 8.
If your DIVA T/A is equipped with analog device ports, you can use
the following calling features during voice calls:
Call Forwarding
Call Forwarding automatically transfers incoming calls to wherever
you are so you never miss a customer call even when you're away
from your home office. Call Forwarding is accessed by dialing a
simple code (e.g. 72#). Not all ISDN Service Providers use the same
dial codes. Ask your ISDN Service Provider for the codes relevant to
you.
If your ISDN service conforms to EZ-ISDN 1A (see page 8), you will
also have VoiceMail. If the number to which you have forwarded
your calls is busy or does not answer, the call will automatically be
forwarded to your VoiceMail. With VoiceMail, the DIVA T/A also
supports Visual Message Waiting Indicator. See “VoiceMail” on page
101 for more information.
Call Forwarding supports Reminder Ring. Reminder Ring causes your
telephone to ring once (for about ½ a second) whenever it forwards a
call. If your phone has Caller ID (see next page), it will display details
of the forwarded call.
Call Waiting
Call Waiting alerts you to an incoming call when you're already on
the phone. You can put one call on hold while you accept another, so
you'll never miss a customer call. It works as follows:
If you receive a second call while on a call, a beep sounds. To answer
the second call, press the receiver button. The first call is then put on