Hayes Microcomputer Products DIVA T/A ISDN - Manual (Page 53)

DIVA T/A ISDN Modem User’s Guide 53
Configure the following parameters:
Parameter Description
Local Switch Type Specifies the ISDN switch type used by your
ISDN service provider.
North American firmware: For most
locations, the default North America (Auto-
Detect) should be used. If the ISDN Switch
Type cannot be automatically detected,
specify National ISDN-1 (NI-1) or AT&T
(5ESS)
International (Excluding North America)
firmware: Europe (Euro ISDN), Japan
(INS-Net64), and Australia (TPH1962).
Note: Australia has two switch types
available: TPH1962 (Microlink) and Euro
ISDN (Onramp); indicate the appropriate
type.
Connect using this
protocol Specifies the ISDN connection protocol you
want to use (it must match the protocol on
the receiving system). For most connections,
Multilink PPP should be used. If it is not
supported, PPP for single B-channel
connections, V.120 and V.110 can be used.
Both PPP and Multilink PPP require that a
PPP communications stack be installed on
your computer.
If your workstation is configured as a
Windows for Workgroups Remote Access
Service (RAS) client, you must configure
the V.120 rate adaption protocol on both the
DIVA T/A workstation and on the remote
device (RAS Server ISDN adapter).
Continued next page…