Hayes Microcomputer Products DIVA T/A ISDN - Manual (Page 54)

DIVA T/A ISDN Modem User’s Guide 54
Parameter Description and Values
Connect using this
protocol
(Continued)
Note: To obtain maximum Multilink PPP
performance, you need a PC equipped with
a UART 16650 (you might need to install a
fast com port card), which supports COM
port speed of 230.4 kbps (versus 115.2 kbps
with 16550).
Note: Multilink PPP does not support the
callback feature used by some servers.
Warning: When using Multilink PPP for
incoming calls, only SPAP or PAP
authentication is supported.
Telephone Number
(1
st /2 nd Number)
Specifies your ISDN number(s).
Note: If you are using a North American
version of the DIVA T/A and your line
supports AutoSPID, ISDN numbers are
automatically detected. For more
information on AutoSPID, refer to page 96.
Enable 2 nd Number Permits the DIVA T/A to use 2 nd Number
information. If your ISDN provider assigns
you two different numbers, select Enable 2
nd
Number.
Service Profile ID
(SPID)
(1 st /2 nd Number)
Specifies your SPID Number(s). The ISDN
switch uses the SPID number to identify
your ISDN equipment. Your ISDN provider
assigns your SPID number(s).
Notes:
If your line supports AutoSPID, SPID
numbers are automatically detected. For
more information on AutoSPID, refer to
page 96
Deselecting the SPID checkbox disables
SPID terminal initialization and configures
the port as a Non-Initializing Terminal. For
more information on Non-Initializing
Terminal mode, refer to page 97.