Hayes Microcomputer Products DIVA T/A ISDN - Manual (Page 38)

DIVA T/A ISDN Modem User’s Guide 38
Specify your ISDN Switch Type, Telephone Number(s), and Service
Profile ID (SPID). Use the table below as a guideline.
Parameter Description and Values
Switch Type Specifies the ISDN switch type used by your
ISDN service provider.
North America: For most locations use
Auto-Detect (Default). If auto-detection is
not possible, specify National ISDN-1 (NI-1)
or AT&T (5ESS)
International (Excluding North America):
Europe (Euro ISDN), Japan (INS-Net64),
Australia - Microlink (TPH1962/TS013), and
Australia - OnRamp (Telstra's ETSI service).
The default setting is Europe.
Use 2 Numbers Activates the “2 nd Number tab”. Use the
second number tab if your ISDN provider
assigns two numbers.
Telephone
Number
(1 st Number/2 nd
Number)
Specifies your ISDN number(s).
Note: If you are using a North American
version of the DIVA T/A and your line
supports AutoSPID, ISDN numbers are
automatically detected. For more
information on AutoSPID, refer to page 96.
Service
Profile ID
(SPID)
(1 st Number/2 nd
Number)
North America
only
Specifies your SPID Number(s). The ISDN
switch uses the SPID number to identify your
ISDN equipment. Your ISDN provider
assigns your SPID number(s).
Notes:
If your line supports AutoSPID, SPID
numbers are automatically detected. For
more information on AutoSPID, refer to page
96.
Deselecting the SPID checkbox disables
SPID terminal initialization and configures
the port as a Non-Initializing Terminal. See
Non-Initializing Terminal mode, on page 97.