Network: how do i, Set up the device and use it on the network – HP 2820 User Manual
Page 163
Network: How do I?
Use this section to answer network questions.
Set up the device and use it on the network
Hewlett-Packard recommends that you use the HP software installer on the CD-ROMs that
came with the device to set up printer drivers for the following network setups.
To configure a network port-connected device configuration (direct
mode or peer-to-peer printing)
In this configuration, the device is connected directly to the network, and all computers on
the network print directly to the device.
Note
This mode is the recommended network configuration for the device.
1. Connect the device directly to the network by inserting a network cable into the device
network port.
2. At the device, use the control panel to print a Configuration page. See
.
3. Insert the device CD-ROM into your computer. If you have already set up your device,
click Install Software to start the software installer. If the software installer does not
start, navigate to the hpsetup.exe file on the CD-ROM and double-click the file.
4. Click Install HP Color LaserJet Software.
5. On the Welcome screen, click Next.
6. On the Installer updates screen, click Yes to search for installer updates on the Web.
7. For Windows 2000, on the Installation Options screen, choose the installation option.
Hewlett-Packard recommends a typical installation, if your system supports it.
8. On the License Agreement screen, read the license agreement, indicate that you
accept the terms, and then click Next.
9. For Windows 2000, on the HP Extended Capabilities screen, choose whether you want
extended capabilities, and then click Next.
10. On the Destination Folder screen, choose the destination folder, and then click Next.
11. On the Ready to Install screen, click Next to begin installation.
Note
If you want to change your settings, instead of clicking Next, click Back to return to previous
screens, and then change the settings.
12. On the Connection Type screen, select Through the network, and then click Next.
13. On the Identify Printer screen, identify the device either by searching or by specifying a
hardware or IP address, which is listed on the Configuration page you printed earlier. In
most cases an IP address is assigned, but you can change it if you want by clicking
Specify the printer by Address on the Identify Printer screen. Click Next.
14. Allow the installation process to complete.
ENWW
Network: How do I?
147