HP 2820 - Manual (Page 46)

3. Extend the paper-length adjustment control at the rear of the tray until the arrow on the
markings on the tray points to the size that you are loading.
4. Load the paper. If this is special paper such as letterhead, load it with the side to be
printed upon face-down and the top edge toward the front of the tray.
Note If you are duplexing manually, see Printing on both sides (duplexing manually) for loading
instructions.
5. Make sure that the stack of paper is flat in the tray at all four corners, and keep it below
the height tabs on the media-length guide in the rear of the tray. Push down on the metal
media-lift plate to lock it into place.
6. Slide the tray into the printer. If you set the rear of the tray to one of the longer sizes, the
back of the tray will protrude from the back of the printer.
Loading documents to scan
Use these instructions to load originals into your device for scanning. For the best quality
scans, use the flatbed scanner.
To load originals onto the flatbed scanner
1. Make sure that the automatic document feeder (ADF) contains no media.
2. Lift the flatbed scanner cover.
3. Place the original document face-down on the flatbed scanner with the upper-left corner
of the document at the lower-right corner of the glass.
4. Gently close the lid.
The document is ready to be scanned.
CAUTION To prevent damaging the device, do not allow the scanner lid to fall onto the flatbed scanner
surface. Always close the scanner lid when the device is not in use.
30 Chapter 4 Using the device ENWW