HP 2820 User Manual
Page 190
Advertising
4. Lifting the green lever, rotate the pick mechanism until it stays open.
5. Open the ADF lid and gently loosen the media by using both hands.
6. When the media is free, gently pull it out in the direction shown.
7. Close the lid to the flatbed scanner.
8. Lower the green lever.
9. Reinstall the cleanout part by inserting it as shown. Push down on the two tabs until the
part snaps into place. Install the cleanout part correctly, because future jamming might
occur if the cleanout part is not replaced correctly.
174
Chapter 11 How do I?
ENWW
Advertising
This manual is related to the following products: