Printing on special media, Glossy paper, Colored paper – HP 2820 User Manual
Page 62: Preprinted forms and letterhead
Printing on special media
Use these guidelines when printing on special types of media.
Note
Use the rear output door (straight-through paper path) when printing on special media.
Glossy paper
●
In either the software application or the driver, select Glossy as the media type, or print
from a tray that is configured for glossy paper.
Select Glossy for media weights up to 105 g/m
2
(28 lb bond). Select Heavy glossy for
media weights up to 120 g/m
2
(32 lb bond).
●
Because this affects all print jobs, it is important to return the printer to its original
settings once the job has printed.
Note
Hewlett-Packard recommends using HP Color LaserJet Soft Gloss paper with this printer.
HP products are designed to work together for optimum printing results. If HP Color LaserJet
Soft Gloss paper is not used with this printer, print quality may be compromised.
Use only glossy papers that are designed for use with HP Color LaserJet printers. Inkjet
glossy papers are not supported for this device.
Colored paper
●
Colored paper should be of the same high quality as white xerographic paper.
●
Pigments used must be able to withstand the printer’s fusing temperature of 190°C (374°
F) for 0.1 second without deterioration.
●
Do not use paper with a colored coating that was added after the paper was produced.
●
The printer creates colors by printing patterns of dots, overlaying and varying their
spacing to produce various colors. Varying the shade or color of the paper will affect the
shades of the printed colors.
Preprinted forms and letterhead
When printing on preprinted forms and letterhead, observe the following guidelines for best
results:
●
Forms and letterhead must be printed with heat-resistant inks that will not melt, vaporize,
or release hazardous emissions when subjected to the printer’s fusing temperature of
approximately 190°C (374°F) for 0.1 second.
●
Inks must be non-flammable and should not adversely affect any printer rollers.
●
Forms and letterhead should be sealed in a moisture-proof wrapping to prevent changes
during storage.
●
Before loading preprinted paper such as forms and letterhead, verify that the ink on the
paper is dry. During the fusing process, wet ink can come off of preprinted paper.
46
Chapter 5 Printing
ENWW