Fujitsu Siemens Computers SPARC Enterprise M8000 User Manual
Page 104
4-14
SPARC Enterprise Mx000 Servers Dynamic Reconfiguration User’s Guide • September 2007
4. Delete the system board.
Execute the deleteboard(8) command to delete the system board.
5. Check the status of the system board.
Execute the showboards(8) command to display system board information, and
then check the status of the system board.
6. Physically replace the system board.
Execute the replacefru(8) command, then follow the displayed instructions to
replace the system board per the Hot Replacement procedure. For information
about Hot Replacement, see the SPARC Enterprise M8000/M9000 Servers Service
Manual.
7. Check the status of the replaced system board.
Execute the showboards(8) command to display system board information, and
then check the status of all related system boards and confirm their registration
in the DCL.
If necessary to change the system board configuration (e.g., number of divisions),
do so by using the setupfru(8) command. If the system board is not registered
in the DCL, register it in the DCL for the target domain by using the setdcl(8)
command.
XSCF> deleteboard -c disconnect 01-0
XSCF> showboards 01-0
XSB
DID(LSB)
Assignment
Pwr
Conn
Conf
Test
Fault
-----------------------------------------------------------------
01-0
00(01)
Assigned
y
n
n
Passed
Normal
XSCF> replacefru
XSCF> showboards 01-0
XSB
DID(LSB)
Assignment
Pwr
Conn
Conf
Test
Fault
-----------------------------------------------------------------
01-0
00(01)
Assigned
y
n
n
Passed
Normal