Fujitsu Siemens Computers SPARC Enterprise M8000 - Manual (Page 148)

A-32 SPARC Enterprise Mx000 Servers Dynamic Reconfiguration User’s Guide • September 2007
[Explanation] Confirming whether DR operation is going to be executed or not.
Input "y" to execute it and "n" to stop it.
XSB#XX-Xwill be configured into DomainID X. Continue? [y|n]:
[Explanation] Confirming whether DR operation is going to be executed or not.
Input "y" to execute it and "n" to stop it.
XSB#XX-X could not be configured into DomainID X due to
operating system error.
[Explanation] An error occurred in DR library of domain OS at configuration
process. The error occurred at configuration management of domain OS.
[Remedy] Find out the cause of the DR failure referring monitoring message and
console message. Try again after resolving cause.
A.2.4 setdcl
XSB is already assigned to an LSB in a running Domain (DomainID
X).
[Explanation] The system board of the specified LSB has already been registered
in DCL.
[Remedy] Power off the domain, or move XSB to the system board pool. Try
again.
LSB#00 is already registered in DCL.
[Explanation] The system board of the specified LSB has already been registered
in DCL.
[Remedy] Confirm the domain, LSB and XSB. Setup data correctly.
LSB#00 has not been registered in DCL yet.
[Explanation] The domain and LSB weren’t set up, when the DCL of no-mem, no-
io and floating-board was changed.
[Remedy] Set up the domain and LSB. Try again.
DomainID X does not exist.
[Explanation] No LSB was set up on the domain, when the DCL of configuration-
policy was changed.
[Remedy] Set up the domain and LSB. Try again.