Fujitsu Siemens Computers SPARC Enterprise M8000 - Manual (Page 57)

Chapter 2 What You Must Know Before Using DR 2-25
2.4.3.4 Flowchart: Replacing System Board
The flow of DR operations and the transition of system board status when a system
board has been replaced are described using the schematic flowchart.
Each system board state indicated in FIGURE 2-8 is the main status that is changed.
The sample status before and after replacement as shown in the figure are explained
below. The actual status after hardware replacement may not match the indicated
status.
For the flow of system board addition processing or deletion processing and the
related system board status, see
Section 2.4.3.1, “Flowchart: Adding a System Board”
on page 2-20 or Section 2.4.3.2, “Flowchart: Deleting a System Board” on page 2-21 ,
respectively.
For details of hardware replacement operations, see the service manual for your
system.