Fujitsu Siemens Computers SPARC Enterprise M8000 - Manual (Page 77)

Chapter 3 DR User Interface 3-15
3.1.6 Adding a System Board
Use the addboard(8) command to add a system board to a domain or reserve the
addition of a system board to a domain based on the DCL. The system board must
already be registered in the target domain’s DCL.
Use the showdcl(8) command to check whether a system board is registered in the
DCL. To register a system board in the DCL, use the setdcl(8) command.
Before executing the addboard(8) command, check the status of the DR-target
domain and system board. You must determine whether you can perform the DR
operation based on the status of the domain and system board.
The following examples show the format and options of the addboard(8) command.
addboard [[-q] -{y|n}] [-f] [-v] [-c configure] -d domain_id xsb [...]
addboard [[-q] -{y|n}] [-f] [-v] -c assign -d domain_id xsb [...]
addboard [[-q] -{y|n}] [-f] [-v] -c reserve -d domain_id xsb [...]
addboard -h
TABLE 3-13 Options of the addboard Command
Option Description
-q Specifies the suppression of output message display.
The -y or -n option determines how output messages are
automatically answered, whether or not the messages themselves are
suppressed (with the -q option) or displayed.
-y Specifies that a response of "yes" is made automatically to all output
messages.
The -y or -n option determines how output messages are
automatically answered, whether or not the messages themselves are
suppressed (with the -q option) or displayed.
-n Specifies that a response of "no" is made automatically to all output
messages.
The-y or -n option determines how output messages are
automatically answered, whether or not the messages themselves are
suppressed (with the -q option) or displayed.
-f Forcibly adds a system board that has not been diagnosed to a
domain. This option for normal DR operations must not be used.
A faulty system board, or a system board where a fault is detected
will not be forcibly added to the destination domain.
-v Displays the progress of this DR command.
If the option is specified with the -q option, the -v option is
ignored.