FARGO electronic DTC500 User Manual
Page 17
RESTRICTED USE ONLY
Fargo Electronics, Inc.
DTC500 Series Card Printer/Encoders User Guide (Rev. 5.0)
17
Reviewing the Lamination Module Sequence of Operations (continued)
Step Process
6
The Card Feed Motor and the Lamination Ribbon Motor activate for the length of
the card.
7
The Lamination Roller Lift Motor cycles until Lamination Roller Lift Sensor detects
state change.
8
The card is fed back to the Flipper Table.
9
The Flipper Table Clutch engages.
10
The Flipper Table Motor activates until the Card is inverted based on the Flipper
offset setting.
11
The Flipper Table Clutch disengages.
12
The card is fed off the Flipper Table.
13
The Flipper Table Clutch engages.
14
The Flipper Table Motor activates until the Flipper Table is homed.
15
The Flipper Table Clutch disengages.
16
Repeat Steps 2 through 7.
17
The card is fed out of the Printer.