FARGO electronic DTC500 - Manual (Page 51)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC500 Series Card Printer/Encoders User Guide (Rev. 5.0) 51
Determining the Ready Status of the Card Lamination Module
Caution (Technician Note): Review these requirements:

If you are using a DTC525 Card Printer, you must have version 2.0.0-b2 or higher of the
Printer
’
s Main Firmware to use the Card Lamination Module.

If you do not have these versions, the Card Lamination Module will not function properly.
To check the version of your Printer
’
s Firmware, simply turn the Printer power OFF and
ON. (Note: The Firmware version will display momentarily on the Printer
’
s LCD display
during startup.)

If you are in need of a Firmware upgrade, please go to Fargo
’
s website (www.fargo.com)
for the latest Firmware file and updating instructions. (Note: This file must be updated
prior connecting the Card Lamination Module to the Printer.)

Technician Note: All DTC525 units manufactured after Serial Number A2350145 are
ready to have a Card Lamination Module attached to them.