FARGO electronic DTC500 - Manual (Page 235)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC500 Series Card Printer/Encoders User Guide (Rev. 5.0) 235
Section 5: Cleaning
This Section deals with the Printer
’
s internal and external maintenance in regards to the
unit's cleaning and general upkeep. (Note: The Printer should be cleaned on a regular basis
to insure that the Printer consistently produces high quality output.)
Danger: Be sure to disconnect the Printer's power cord whenever performing any
type of maintenance procedure unless otherwise directed.
Safety Messages (review carefully)
Symbol Critical Instructions for Safety purposes
Danger: Failure to follow these installation guidelines can result in death or
serious injury.
Information that raises potential safety issues is indicated by a warning
symbol (as shown to the below).

To prevent personal injury, refer to the following safety messages
before performing an operation preceded by this symbol.

To prevent personal injury, always remove the power cord prior to
performing repair procedures, unless otherwise specified.

To prevent personal injury, make sure only qualified personnel
perform these procedures.
Caution: This device is electrostatically sensitive. It can be damaged if
exposed to static electricity discharges.
Information that raises potential electrostatic safety issues is indicated by a
warning symbol (as shown to the below).

To prevent equipment or media damage, refer to the following safety
messages before performing an operation preceded by this symbol.

To prevent equipment or media damage, observe all established
Electrostatic Discharge (ESD) procedures while handling cables in or
near the Circuit Board and Printhead Assemblies.

To prevent equipment or media damage, always wear an appropriate
personal grounding device (e.g., a high quality wrist strap grounded to
avoid potential damage).

To prevent equipment or media damage, always remove the Ribbon
and Cards from the Printer before making any repairs, unless otherwise
specified.

To prevent equipment or media damage, take jewelry off of fingers
and hands, as well as thoroughly clean hands to remove oil and debris
before working on the Printer.