FARGO electronic DTC500 - Manual (Page 269)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC500 Series Card Printer/Encoders User Guide (Rev. 5.0) 269
Changing the BAUD Rate Settings
Apply this setting only if the Printer provides support for the Embedded Fonts and Bar Codes
option.
Step Procedure
1 Select MENU, Setup Printer and BAUD Rate Settings.
2 Change to the appropriate option: 19200 or 9600.
3 Press the Select button to save the value.
Adjusting the Flipper Offset
Step Procedure
1 Select MENU, Setup Printer and Flipper Offset.
2 Select Level or Encoder Angle.

Use the Level option to set the position of the Flipper so it is level with the
card path.

Use the Encoder Angle option to fine tune the position of the Flipper in
relation to the Printer's built-in Encoder if your Printer is equipped with this
option.
3 Change these settings in small increments if the card is not feeding correctly off
the Card Flipper onto the card path or into he Encoder.

Decrease the Flipper Offset setting to lower the lip of the Flipper.

Increase the setting to raise it.
4 Press the Select button to save the value.