FARGO electronic DTC500 User Manual
Page 305
RESTRICTED USE ONLY
Fargo Electronics, Inc.
DTC500 Series Card Printer/Encoders User Guide (Rev. 5.0)
305
Upgrading the Firmware to Version 1.5.1 (continued)
Step
Procedure
4
Start the Update.
a. Go to the Printer LCD and select Start.
b. Go to the PC and click on Send Update.
(Note: The PC and Printer LCD will show update status as the Firmware is
transferred.)
5
Finish the Update. (Note: Upon completion, the LCD will state Upgrade
Successful.)
a. Press the EXIT button and cycle the power to the Printer.
b. Upon power-up, confirm that the new Firmware (Version 1.5.1) appears in
the LCD window.
c. Click on the Exit button to close the Updater dialog box.
6
a. If the Update Failed or Update System Now message appears, repeat the
Powering up the Unit and confirming its Ready status procedure in this
same document.
b. If the failure persists, contact the FARGO Technical Support for assistance.