FARGO electronic DTC500 - Manual (Page 21)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC500 Series Card Printer/Encoders User Guide (Rev. 5.0) 21
Loading the Overlaminate _____________________________________________________________134
Adjusting the Card Lamination Module __________________________________________________137
Adjusting the Card Flattener_________________________________________________________137
Adjusting the Card Guide Rail _______________________________________________________139
Adjusting the Internal Card Guide ____________________________________________________143
Attaching the Card Lamination Module ________________________________________________145
Section 4: Printer Adjustments _________________________________________________ 151
Safety Messages (review carefully)______________________________________________________151
Adjusting the Internal Card Guide ____________________________________________________152
Printer Driver options ________________________________________________________________154
Using the Device options tab___________________________________________________________154
Adjusting for the Ribbon Type _______________________________________________________155
Adjusting for the Color matching _____________________________________________________156
Adjusting for the Resin Dither _______________________________________________________157
Using the Print Both Sides option (DTC520/DTC525 only) ________________________________158
Using the Split 1 Set of Ribbon Panels option (DTC520/DTC525 only) _______________________159
Using the Print Back Side First option _________________________________________________160
Using the Print on Back Side Only option (DTC520/DTC525 only) __________________________161
Using the Rotate Front by 180 Degrees option___________________________________________162
Using the Rotate Back by 180 Degrees option (DTC520/DTC525 only)_______________________163
Using the Buffer Single Card option __________________________________________________164
Using the Link Card to Print Job option ________________________________________________165
Using the Disable Printing option_____________________________________________________166
Using the Image Color tab_____________________________________________________________167
Using the K Panel Resin tab ___________________________________________________________171
Selecting the Full Card with the K Panel Resin tab _______________________________________172
Selecting the Defined Area(s) with the K Panel Resin tab __________________________________173
Selecting the Undefined Area(s) with the K Panel Resin tab ________________________________174
Defining the Area to activate the Card Grid _____________________________________________175
Measuring the Total Card area _______________________________________________________176
Defining the positioning of the area on the Card _________________________________________178
Selecting the Print YMC under the K and Print K Only options _____________________________180
Using the Magnetic Encoding tab _______________________________________________________182
Using the Encoding Mode option _____________________________________________________183
Encoding the Mode/Coercivity/Magnetic Track Selection__________________________________185
Using the Magnetic Track Selection option _____________________________________________187
Reviewing the Enable MLE Support checkbox __________________________________________188
Using the Magnetic Track options ____________________________________________________189
Using the Bit Density radio buttons ___________________________________________________190
Using the Character Size radio buttons_________________________________________________190
Using the ASCII Offset ____________________________________________________________191
Using the LRC Generation radio buttons _______________________________________________192
Using the Character Parity radio buttons _______________________________________________192
Using the Verification option ________________________________________________________193
Reviewing the Shift Data Left _______________________________________________________194
Reviewing the ISO Track Locations___________________________________________________195
Reviewing the Sample String ________________________________________________________195
Sending the Track Information _______________________________________________________196
Reviewing the ASCII Code and Character Table _________________________________________197
Using the Overlay/Print Area tab _______________________________________________________198
Using the Overlay/Print Area dropdown menu __________________________________________199
Using the Overlay/Print Area ________________________________________________________200
Using Security Options (Visual Security Solutions)_______________________________________206
Selecting Orientation - Landscape under Card tab ________________________________________207
Selecting the Visual Security Solutions dropdown menu (A to D) ___________________________208