FUJITSU XG Series P3NK-4452-01ENZD User Manual
Page 193
XG Series User's Guide
Chapter 5 Command Reference
LAN Information Settings
193
Explanation
Set DSCP value rewriting conditions.
Rewrite the DSCP value of a packet, which has satisfied conditions, to the specified
DSCP value.
Caution
Note 1.
If none of "acl ip" definition exist on the access control list which has been specified by
<acl> or if the access control list specified by <acl> does not exist, the packets are not
filtered.
[XG2600]
Note 2.
This command is unavailable if the allowable upper limit for the device is exceeded.
The allowable upper limits are as follows.
• Upper limit based on "commands"
64 commands for the entire device.
Up to 64 commands can be set for the entire device, including the
,
,
commands.
The priority for each command is as follows.
1)
command
A smaller Ethernet port number has a higher priority among Ethernet ports.
2)
command
A smaller VLAN ID has a higher priority among VLANs.
3)
A smaller lan definition number has a higher priority among lans.
4)
A smaller Ethernet port number has a higher priority among Ethernet ports.
5)
A smaller VLAN ID has a higher priority among VLANs.
6)
command
A smaller lan definition number has a higher priority among lans.
• Upper limit based on "masks"
64 masks for the entire device.
Up to 64 masks can be set for the entire device, including the
,
commands.
The priority for each command is as follows.
1)
commands
2)
command
A smaller Ethernet port number has a higher priority among Ethernet ports.
3)
command
A smaller VLAN ID has a higher priority among VLANs.
4)
A smaller lan definition number has a higher priority among lans.