FUJITSU XG Series P3NK-4452-01ENZD - Manual (Page 484)

XG Series User's Guide Chapter 5 Command Reference
LLDP Counter, Log, Statistics, and Status Display and Clear Operation
Commands
484
19) System Capabilities information
Value which is sent with System Capabilities TLV
info=
: Available function
enabled= : Enabled function
Bridge
: Bridge functon
Router : Router function
When system-description is disabled by lldp info command, this value is not
displayed.
20) Management address information
Value which is sent with Management Address TLV
When SNMP agent address is set, IPv4 address and MAC address are
displayed.
When management-address is disabled by lldp info command, this value is not
displayed.
21) Port VLAN ID information
Value which is sen with ID TLV
When port-vlan-id is disabled by lldp info command, this value is not displayed.
22) Protocol information
Value which is sent with ocol VLAN ID TLV
When port-and-protocol-vlan-id is disabled by lldp info command, this value is
not displayed.
23) VLAN name information
Value which is sent with IEEE802.1 VLAN Name TLV
When vlan-name is disabled by lldp info command, this value is not displayed.
24) Protocol ID information
Value which is sent with IEEE802.1 Protocol Identity TLV
This value is not displayed.
25) MAC/PHY Configuration/Status information
Value which is sent with IEEE802.3 MAC/PHY Configuration/Status TLV.
When mac-phy-configuration-status is disabled by lldp info command, this value
is not displayed.
26) Power via MDI information
Value which is sent with IEEE802.3 Power Via MDI TLV
support=
: Function Information
PSE : Power supply function
PD : Power demand function
not supported : No function
supported : Supported
disabled : Disable function
enabled : Enable function
When power-via-mdi is disabled by lldp info command,
this value is not displayed.
27) Linkaggregation information
Value which is sent with linkaggregation TLV
When link-aggregation is disabled by lldp info command, this value is not
displayed.