FUJITSU XG Series P3NK-4452-01ENZD - Manual (Page 482)

XG Series User's Guide Chapter 5 Command Reference
LLDP Counter, Log, Statistics, and Status Display and Clear Operation
Commands
482
(Continued)
1) LLDPDU send interval time(s)
Setting value by lldp send interval command
2) LLDP hold count (times)
Setting value by lldp send hold command
3) LLDP Send delay time(s)
Setting value by lldp send interval command
4) LLDP Reinit delay time(s)
Seting value by lldp reinit delay command
5) LLDP SNMP Notification Trap interval time (s)
Setting value by lldp notification interval command
6) Physical port number
Ether port number
7) Mode
Setting value by lldp mode command
enable
: send and recive
send : send only
receive : recive only
When mode is receive, information from (8) to (28) is not displayed.
8) LLDPDU (LLDP Protocol Data Unit) Size
LLDPDU size (octets)
[PORT 8]
Configuration Mode : send
Send LLDPDU size : 179 octets
Chassis ID : subtype=4(MAC) info=00:0b:5d:fd:05:b2ц
Port ID : subtype=5(ifName) info="8"
Time To Live(TTL) : 120 seconds
Port Description : info="EthernetPort(ether8)"
System Description : info="'SBAX2' '1.2 V01.00' 'Wed Feb 13 15:23:07 JST
2008'"
System Capabilities : info=Bridge,Router
enabled=Bridge
Management Address : address subtype=1(IPv4) info=192.168.1.1
interface number subtype=2(ifIndex) info=1
oid=""
Management Address : address subtype=6(MAC) info=00:0b:5d:fd:05:ba
interface number subtype=2(ifIndex) info=7008
oid=""
IEEE802.1
Port VLAN ID : PVID=1
Port And Protocol VLAN ID : flags=supported,disabled
PPVID=0
VLAN Name : VID=1
name="default"
IEEE802.3
MAC/PHY Configuration/Status : support/status=supported,enabled
capability=1(10BASE-T half duplex mode),
2(10BASE-T full duplex mode),
4(100BASE-TX half duplex mode),
5(100BASE-TX full duplex mode),
8(PAUSE for full-duplex links),
11(Asymmetric and Symmetric PAUSE
for full-duplex links),
15(1000BASE-T full duplex mode)
type=16(100BASE-TX full duplex mode)
SNMP Notification Trap Send : disable
Entry:2 ---(30)