FUJITSU F2MCTM-16LX - Manual (Page 156)

140
CHAPTER 8 LOW-POWER CONSUMPTION MODE
Table 8.3-1 Functions of Low-power Consumption Mode Control Register (LPMCR)
Bit name Function
bit7 STP:
Stop mode bit This bit transits to the stop mode.
When the bit is set to "0": No effect.
When the bit is set to "1": The CPU enters the stop mode.
Read: "0" is always read.
•
The bit is initialized to "0" when a reset or external interrupt occurs.
bit6 SLP:
Sleep mode bit This bit shift to sleep mode
When the bit is set to "0": No effect.
When the bit is set to "1": The CPU enters the sleep mode.
Read: "0" is always read.
•
The bit is initialized to "0" when a reset or external interrupt occurs.
• When the STP and SLP bits are set to "1" at the same time, the STP bit
supersedes the SLP bit, causing a transition to stop mode.
bit5 SPL:
Pin state specification bit The bit is used to set the state of input/output pins after transition to the stop
mode, watch mode, or timebase timer mode.
When the bit is set to "0": The current level of input/output pins is held.
When the bit is set to "1": The I/O pins enter a high impedance state.
•
The bit is initialized to "0" at a reset.
bit4 RST:
Internal reset signal
generation bit This bit generates software reset.
When the bit is set to "0": An internal reset signal for three machine cycles
is generated.
When the bit is set to "1": No effect
Read: "1" is always read.
bit3 TMD:
Watch mode bit This bit shift to watch mode or timebase timer mode
When the bit is set to "0": If the main clock mode or PLL clock mode is
used, the bit transits to the timebase timer mode.
If the sub-clock mode is used, the bit transits to
the watch mode.
When the bit is set to "1": No effect
•
The bit is set to "1" when a reset or interrupt occurs.
Read: "1" is always read.
bit1
bit2 CG1, CG0:
CPU suspended cycle
number select bits These bits are used to set the halt cycle count of the CPU clock in the CPU
intermittent operation mode.
•
Any reset causes the bit to return to the reset value.
bit0 Reserved: reserved bit Always set this bit to "0".