FUJITSU F2MCTM-16LX - Manual (Page 518)

502
CHAPTER 21 CAN CONTROLLER
21.12 Setting the CAN Direct Mode Register
To operate CAN normally, this register must be set correctly.
■ CAN Direct Mode Register (CDMR) (Only MB90V340)
Figure 21.12-1 Configuration of the CAN Direct Mode Register (CDMR) (Only MB90V340)
Note:
MB90360 does not have the clock modulation function.
So, at using CAN controller, the DIRECT bit of the register must be set "1".
Initial value
X X X X X X X 0
B
Address:
H
CAN0: 00796E
CDMR
- - - -
R/W - - - -
- - - DIRECT
- - -
7 6 5 4 3 2 1 0
X
-
R/W : Readable and writable
: Undefined value
: Undefined
Table 21.12-1 Function of CAN Direct Mode Register (CDMR)
Bit Name Function
bit 7 to 1 Undefined bits -
bit 0 DIRECT If the clock modulation is set (initial state), the bit should be set "0".
If the clock modulation is not set, the bit should be set "1".